@device(x2700) @majorheading[TelePAC Fault and Crash History] @verbatim[ ?? Aug 85 TelePAC delivered on loan ?? Oct 85 Version: 1256 ?? Oct 85 Crash while configuring it ================================================================= ?? Jan 86 H Harware fault on CPU board 30 Jan 86 Version 0167 (major release) 6 Feb 86 Version 0260 (corrections) 17 Mar 86 Version 0368 (corrections & enhan) 18 Mar 86 07.30 O Ops reloaded in an attempt (failed) to clear line 18 Mar 86 13.00 O Re-boot to enable passwords 18 Mar 86 13.45 S Crashed (no buffs) when erte stopped (92 calls) 19 Mar 86 00.00 O Re-boot to enable Low Buff Limit 28 Mar 86 ************** Delivery of New TelePAC - Version 0464 31 Mar 86 23.55 L O Re-boot to change channel numbers on JANET link(80) 1 Apr 86 13.00 L O Re-boot to change channel numbers on JANET link(64) ------------------------------------------------------------------------- 8 Apr 86 O New Telepac brought into service - version 0466 Problems with a clocked line to lau 07 on the CPSE, it produced a steady rate of crc errors & the line was brought down by a BAD ADDRESS on the TelePAC 10 Apr 86 13.00 O Re-boot to change no of channels 23 Apr 86 O SEEL engineer powered-off by accident ----------------------------------------------------------------------- 29 Apr 86 ************** Delivery of full 30 line, 2Mb Telepac - s/w vsn 0468 2 MAY 86 13.00 O REBOOT to change no. of logical channels 14 May 86 13.00 O Put version 0451 into the 2Mb Telepac 15 May 86 13.00 O Reverted to vsn 0468 (256 byte pkt problems) 29 May 86 00.00 {S} Bus Error on TEST Telepac (while running data in test) 30 May 86 11.00 {N} I-Field Error brought down a PAD line (timed by PAD - 5 metre cable) on TEST Telepac - NO OTHER FAULTS Counted 21 Jul 86 08.00 H Hardware fault over weeked, backplane back at 1500 with 4 lines missing 22 Jul 86 13.00 O Backplane replaced ?? Jul 86 13.00 ? Replacement of V24 boards started to fix CRC problems 30 Jul 86 10.30 H Crashed with BUS MASTER on soid, pushed board in & reset 28 Aug 86 13.00 O Version 664 installed in main TelePAC 30 Sep 86 2nd TelePAC delivered 5 Sep 86 10.00 1 H Bus Master, lines 3/4 on solid, pushed board but reoccured immediately, swapped DIO with 2nd TelePAC. 5 Sep 86 1 N Line 19 again failed to start properly on the power up 11 Sep 86 13.00 1 O DIO board #1 swapped with board #7 on telepac #2 suspected h/w problem as blocks were being concatenated 11 Sep 86 13.00 2 O See above 18 Sep 86 13.00 1 O DIO board #9 (line 18) swapped out 18 Sep 86 13.00 2 O DIO boards 2 & 7 swapped out (2 caused Bus Master problems on T1 & L2 problems on T2) ]