@make[report]
@device[x2700]
@majorheading[TelePAC]
@heading[Restart Procedure]
The @B{TelePAC} can be restarted by simply pressing the @B['reset'] switch
on the front.

If it has crashed, it sometimes will not restart using the switch, in this
case the power should be switched off and on by pulling out the plug.

The @B{TelePAC} will use the stored configuration in its battery backed RAM.
If this fails it will automaticaly attempt to load a configuration from its
floppy disk.  The current configuration is on the floppy in the drive, there
is also a backup floppy disk.

Only if all this fails will it now be necessary to load a configuration by
typing it in at the console.